so I went in to clean and got sidetracked, cleaned my sewing machine and decided to stuff the dressform bra. Big mistake buying a cheap new one, I could not get the measurement. Sigh I fetched my best fitting smooth bra and stuffed that and got the right measurement pdq. Bust point the correct measurement feom the shoulder/neck. Bust points the correct distance apart
That was the start of the roll, ignoring the mess everywhere. The padding in the parcel was just right, bamboo batting and thin cream felt. I made and pinned circumferences on the form, measured my front side to side and to my delight the form back was good without padding but sigh again, all the extra is on my front. Smiles again, so what, most women my age have that
Batting first then felt to finish and I hardly needed to pin, it all stuck together wonderfully. I carried on and all was done as accurate as could be and double quick time. By some miracle I found my curved needle, last used when I slaved away at super thick padding on my thin adjustoform, the one that had lurked under the stairs for 5 years. Some quick stitches to hold it all in place without pins. The hardest was the bulk that had to curve into the under bust
She looks good tbh. Next is the lycra and for that I need a tube, I will try 4" less than hip size, put it on her inside out and pull to shape and pin. Then I will do a final sew, cut the excess off and dress her. I will use my most stretchy stitch and a stretch needle. She will undress easily if I need to change shape in time
Bit tip: if you get a dressform then get one smaller than you are, not much smaller but definitely not bigger. She is going to be tremendously useful for any top down knitting that I do as well as tops, dresses and skirts
The last one took me 2 weeks full on, it was horrible to do